Hypertherm Powermax125 cut chart: cutting speeds and pierce delays by thickness

The values below come from the Powermax125 Operator Manual 808080 rev 3.1: for each thickness, the chart's best-quality speed and pierce delay at the highest amperage the chart lists for it, on oxygen for mild steel and on nitrogen for stainless and aluminium where the system offers them. The inch table is the chart's own, not a conversion.

These are the maker's figures for a new, well-set machine at its recommended settings. Your machine may cut slower with worn consumables, or faster when the edge allows it. A starting point, not a quote.

In Nest&Quote a machine's speed table is filled from this chart in one click, each row with its source, for you to check and correct. The cut time and the price then come from your own rows, and real run times adjust the rest.

Use these speeds in Nest&QuoteCut-time calculator

Plasma: other charts

• Hypertherm Powermax45 XP cut chart: cutting speeds and pierce delays by thickness
• Hypertherm Powermax65 cut chart: cutting speeds and pierce delays by thickness
• Hypertherm Powermax85 cut chart: cutting speeds and pierce delays by thickness
• Hypertherm Powermax105 cut chart: cutting speeds and pierce delays by thickness
• Hypertherm HPR130XD cut chart: cutting speeds and pierce delays by thickness
• Hypertherm HPR260XD cut chart: cutting speeds and pierce delays by thickness
• Hypertherm HPR400XD cut chart: cutting speeds and pierce delays by thickness
• Hypertherm XPR170 cut chart: cutting speeds and pierce delays by thickness
• Hypertherm XPR300 cut chart: cutting speeds and pierce delays by thickness
• All cut charts
• Plasma: nesting and quoting